DYNACORD IPX SERIES AMPLIFIERS

Dynacord premiered its new IPX series multi-channel power amplifiers incorporating OMNEO IP networking architecture. IPX series embodies several proprietary amplifier technologies developed by Dynacord engineering.

Engineered and manufactured in Germany, the IPX series from Dynacord comprises three four-channel models and one eight-channel model, offering a power density of 5kW, 10kW and even 20kW from a single amplifier with all channels driven. With outstanding audio performance, integration flexibility and reliability, IPX series amplifiers can cover a wide range of demanding fixed install venues, from concert halls, art centres, theatres, and houses of worship to distributed sound systems in stadiums and entertainment centres. Combined with high energy savings via the new Dynacord Eco Rail mode, they represent an outstanding value for every mid- to large-sized audio installation.

IPX series offers high flexibility for a variety of installation scenarios. This is ensured by several power drive options utilising Dynacord’s patented VLD (Variable Load Drive) technology as well as the newly developed parallel and bridged parallel operation modes. VLD technology (IPX5:4 and IPX10:8) allows the available output power of 1,250 watts per channel to be used at either four or eight Ohms, or via 70V or 100V lines in direct drive mode.

The integrated OMNEO interface with a primary and secondary port allows the use of eight channels from a Dante audio network, while remote and supervision parameters run on OCA protocol (AES70), open for third-party integration. Redundancy options include glitch-free and RSTP (Rapid Spanning Tree Protocol) to suit individual requirements and existing infrastructure.

The new Eco Rail technology developed by Dynacord helps to reduce overall power consumption up to 50%, both protecting the environment and significantly lowering the total cost of ownership, while maintaining high-quality audio and operational safety at all times. The fully DSP-controlled amplifier and power supply constantly monitors up to 280 parameters simultaneously to assure that even under challenging operating conditions such as mains power fluctuations, the IPX series from Dynacord continues to perform at highest possible level, rather than switching into a protect mode and stop operation.

The IPX series offers 96kHz high-resolution digital signal processing for the highest performance, internal analogue-to-digital conversion with ultra-low latency, and a superior signal-to-noise ratio. The three DSP blocks are split into user, array and speaker processing controls, each featuring a wide range of equalisation, delay, level options and even asymmetric filters to adapt to almost any application. Complete remote control and supervision is available via the powerful IRIS-Net software and allows the IPX series to be seamlessly integrated into both existing and new installations.

Dynacord: www.dynacord.com
Australian Distributor: www.boschcommunications.com.au